Alloy Steel Pipes Hardness Testing Methods And Tools
Tensile testing is to make alloy steel pipes into specimens, pull the specimens to fracture on a tensile testing machine, and then measure one or several mechanical properties. Usually only tensile strength, yield strength, elongation after fracture and fracture area are measured. Shrinkage. Tensile test is the basic mechanical property test method for alloy steel pipes. Almost all alloy steel pipes require tensile tests as long as they have requirements for mechanical properties. Especially for alloy steel pipes whose shapes are inconvenient for hardness testing, tensile testing has become the only means of testing mechanical properties.
The alloy steel pipe hardness test is to slowly press a hard indenter into the surface of the sample according to specified conditions, and then test the indentation depth or size to determine the hardness of the alloy steel pipe. Hardness test is a simple, rapid and easy-to-implement method in mechanical property testing of alloy steel pipes. The hardness test is non-destructive, and there is an approximate conversion relationship between the hardness value and the tensile strength value of the alloy steel pipe. The hardness value of alloy steel pipe can be converted into tensile strength value, which is of great practical significance.
Since the tensile test is inconvenient to test and it is convenient to convert hardness to strength, people are increasingly testing only the hardness of alloy steel pipes and less often their strength. Especially due to the continuous advancement and innovation of hardness tester manufacturing technology, it is now possible to directly test the hardness of some alloy steel pipes that were previously unable to be directly tested for hardness. Therefore, there is a trend that hardness testing gradually replaces tensile testing.
Most of the national standards for alloy steel pipes stipulate both tensile testing and hardness testing. For those alloy steel pipes that are not convenient for hardness testing, such as alloy steel pipes, only tensile testing is specified.
For annealed 16mn seamless steel pipes with an inner diameter of above 6.0mm and a wall thickness of below 13mm, the W-B75 Webster hardness tester can be used. The test is very fast and simple, and is suitable for rapid and non-destructive qualification inspection of alloy steel pipes. Seamless steel pipes with an inner diameter of alloy steel pipes greater than 30mm and a wall thickness greater than 1.2mm are tested for HRB and HRC hardness using a Rockwell hardness tester. Seamless steel pipes with an inner diameter of alloy steel pipes greater than 30mm and a wall thickness less than 1.2mm are tested for HRT or HRN hardness using a surface Rockwell hardness tester. For seamless steel pipes with an inner diameter less than 0mm and greater than 4.8mm, use a special Rockwell hardness tester for pipes to test the HR15T hardness. When the inner diameter of the alloy steel pipe is greater than 26mm, the hardness of the inner wall of the alloy steel pipe can also be tested with a Rockwell or surface Rockwell hardness tester.