Jun 23, 2025 Leave a message

Quality inspection of precision seamless pipes

What are the common nondestructive testing methods?
Eddy current testing (ECT) is suitable for surface cracks and wall thickness measurement, with a speed of up to 3 meters/minute. Ultrasonic testing (UT) can detect internal defects (such as inclusions), requires coupling agent and has high requirements for operators. Radiographic testing (RT) is used for welds and thick-walled pipes, but it is expensive and requires protection. Magnetic particle testing (MT) is only suitable for ferromagnetic materials and is sensitive to surface cracks. Penetrant testing (PT) is used for non-porous materials and can show micron-level defects. The selection method needs to be combined with the defect type and standard requirements (such as API 5L stipulates UT+ECT combination).

How to measure the inner wall roughness?
Contact profilometers (such as Taylor Hobson) use a probe to directly scan the inner wall with an accuracy of 0.01μm, but can only measure local areas. Non-contact laser confocal microscopy is suitable for small-diameter pipes (such as <20mm) and can generate 3D topography. The comparison method uses standard roughness samples for visual comparison, which is fast but highly subjective. Online detection can be achieved through endoscope + image analysis software. The report must indicate the measurement position (such as axial/circumferential) and sampling length (usually 0.8mm-2.5mm).

Standard process for mechanical properties testing?

Tensile test: Prepare specimens (usually longitudinal strips) according to ASTM A370 to test yield strength (Rp0.2), tensile strength and elongation. Hardness test usually uses Rockwell (HRB/HRC) or Vickers (HV) method, and the deformation zone of the pipe end needs to be avoided. Flattening test: Press the pipe section to a specified height (such as D/3) to check whether it is cracked. The expansion test uses a 30° taper punch to expand to 1.2 times the outer diameter to evaluate plasticity. Impact test (such as -20℃ Charpy V-notch) is used for low-temperature service pipes. All data must be kept in original records for reference.

Tools for detecting dimensional tolerances?
Outer diameter uses a micrometer (resolution 0.001mm) or a laser diameter gauge (online detection accuracy ±0.002mm). The preferred method for measuring wall thickness is an ultrasonic thickness gauge (calibrated to ±0.01mm), or microscopic measurement after cutting the pipe. The ovality is measured by a V-block + dial indicator to measure the maximum-minimum diameter difference of the same section. For straightness detection, the pipe needs to be placed on a platform and the maximum gap is measured with a feeler gauge. Full-size detection needs to be carried out according to the GB/T 2828.1 sampling plan, and 100% inspection of key dimensions.

Is chemical composition analysis necessary?
Material grade verification requires testing of main elements such as C, Mn, Si, P, and S (such as 304 stainless steel requires Cr 18%-20%). Trace elements (such as Nb and Ti) affect weldability and corrosion resistance, and require spectral analysis (OES). Hydrogen, oxygen, and nitrogen analysis (such as LECO instrument) prevents the risk of hydrogen embrittlement. Mixing of raw materials may lead to batch scrapping (such as 316L mistakenly using 304). Third-party reports (such as SGS) must indicate the test standards (such as ASTM E415), and imported materials often require PMI (positive material identification).

info-259-194info-268-188info-259-194

Send Inquiry