Jun 30, 2025 Leave a message

Key points for processing and installation of 16Mn alloy steel pipes

What issues should be paid attention to when cutting 16Mn alloy steel pipes?
When cutting 16Mn alloy steel pipes, it is recommended to use plasma cutting, laser cutting or sawing machines to avoid excessive heat-affected zones. If flame cutting is used, it is necessary to preheat to 150-200℃ to prevent the cut from hardening. After cutting, the burrs should be removed by grinding, and magnetic particle flaw detection should be used to check for microcracks. For precision parts, it is recommended to use cold saws or lathes to ensure dimensional accuracy. Cutting waste needs to be recycled in a classified manner to avoid mixing with other materials to affect the smelting quality.

What are the methods for bending 16Mn alloy steel pipes?
The bending of 16Mn alloy steel pipes can be done by cold bending or hot bending. Cold bending is suitable for thin wall thickness (<10mm) or small curvature radius, and a mandrel is required to prevent wrinkles. Hot bending (heating to 900-950℃) is suitable for thick-walled pipes or large-angle bending, but the temperature needs to be controlled to avoid overburning. After bending, the pipe should be normalized to eliminate residual stress. For high-precision bending (such as hydraulic pipelines), a CNC pipe bender is required to ensure consistency. The bending radius is generally not less than 3 times the pipe diameter to avoid excessive thinning of the outer wall.

What are the preparations before welding 16Mn alloy steel pipes?
Before welding, the oil and rust within 20mm on the groove and both sides must be thoroughly cleaned. An angle grinder or chemical cleaning is recommended. The groove angle is usually 60°±5°, the blunt edge is 1-2mm, and the gap is 2-3mm. For thick-walled pipes (>12mm), 150-200℃ preheating is required and monitored with an infrared thermometer. The welding rod should be dried at 350℃ for 1 hour and taken out as needed. Use a special clamp to ensure concentricity when assembling, and the misalignment should not exceed 10% of the wall thickness.

How to determine the support spacing during installation of 16Mn alloy steel pipes?
The support spacing of 16Mn alloy steel pipes needs to be calculated based on the pipe diameter, wall thickness, medium weight and temperature, generally referring to GB/T 17116 standard. For example, the span of DN200 normal temperature water pipes is about 5-6m, while high temperature steam pipes need to be shortened to 3-4m. The bracket should use sliding supports or spring hangers to avoid stress concentration caused by thermal expansion and contraction. In a vibrating environment (such as a pump room), shock-absorbing pads need to be added. At least one guide bracket is set for each floor height of the vertical pipeline to prevent lateral displacement.

What are the inspection and maintenance requirements for 16Mn alloy steel pipes after installation?
After installation, water pressure test (1.5 times the design pressure), ultrasonic flaw detection (UT) and radiographic flaw detection (RT) spot checks are required. Regular maintenance includes: ① Check the damage of the anti-corrosion layer every year; ② Measure the thickness of high-temperature pipes every 3 years; ③ Check the tightness of bolts at the vibrating parts every month; ④ Check the integrity of the insulation layer before winter; ⑤ Establish corrosion monitoring points (such as hanging plate test). If local corrosion is found, composite materials can be used for repair, while serious defects require replacement of the entire section.

info-259-194info-259-194info-259-194

Send Inquiry