What are the precautions for field welding of straight seam welded pipes?
For field welding, weather conditions should be checked in advance to avoid working in rainy days or high humidity environments to prevent hydrogen-induced cracks. Before welding, oil, rust and moisture within 20mm of the groove and both sides must be thoroughly cleaned to ensure welding quality. Use low-hydrogen welding rods (such as E5015) and strictly dry (350℃×1h), and the flux needs to be sealed and stored to prevent moisture. During welding, the interlayer temperature must be controlled (such as Q345B steel requires ≤250℃) to avoid overheating and affecting performance. After welding, insulation and slow cooling are required. If necessary, asbestos felt should be used to cover to reduce residual stress.
What specifications should be followed in the design of pipeline support spacing?
The calculation of support spacing needs to take into account the stiffness of the pipe, the weight of the medium and the external load, and is usually carried out according to ASME B31.3 or GB 50316 standards. For DN200 carbon steel pipes, the horizontal laying time of water medium is about 4-5m, and the steam pipe needs to be shortened to 3-4m. Vertical pipe supports should be equipped with load-bearing rings with a spacing of no more than 6m. The support material must match the pipe material (such as 304 support for stainless steel pipes), and insulating gaskets must be installed to prevent electrochemical corrosion. Anti-seismic supports must be added in earthquake zones and verified according to GB 50981.
How to monitor pipeline corrosion through intelligent technology?
Using intelligent pipe cleaning devices (PIGs) equipped with ultrasonic or magnetic flux probes, the remaining wall thickness can be measured online with an accuracy of ±0.1mm. Install corrosion monitoring coupons (such as carbon steel and copper alloys) to regularly sample and analyze corrosion rates. Distributed fiber sensing systems (DTS) can monitor temperature strain in real time and locate corrosion hotspots. For high-risk sections, use drones equipped with infrared thermal imagers to detect insulation damage. Data is integrated into the GIS platform to realize intelligent corrosion prediction and maintenance decision-making.
What are the emergency repair methods for pipeline leaks?
Small hole leaks (<10mm) can be plugged with pressure, such as clamp glue injection or magnetic pluggers. Large defects require cutting and replacing pipe sections, and gas replacement (oxygen content <1%) is required before welding. Composite material repair (such as carbon fiber sleeve) is suitable for temporary repair, and the pressure bearing capacity can reach 80% of the original pipe. Buried pipelines need to be excavated and then partially repaired with epoxy resin lining. All repairs require a 24-hour pressure test to verify the sealing.
How to establish a mathematical model for pipeline life assessment?
Based on the wall thickness measurement data, the ASME B31G standard is used to calculate the residual strength, and the critical life is predicted considering the corrosion rate (such as 0.1mm/year). Monte Carlo simulation can analyze the failure probability under the influence of multiple factors (pressure fluctuations, soil corrosiveness). Fatigue life assessment requires the combination of S-N curves and rain flow counting method to count the number of load cycles. Machine learning models can use historical inspection data to optimize prediction accuracy. Finally, the risk matrix is output to guide the priority maintenance plan.








