Q1: What are the common failure forms of Q235 steel pipe?
Uniform corrosion (annual thinning> 0.2mm needs attention) often occurs in chemical humid environment. Pitting perforation is often caused by local destruction of passivation film by chloride ions (Cl⁻> 200ppm). Stress corrosion cracking (SCC) is more common in cold-worked unannealed parts. Fatigue fracture often occurs in the heat-affected zone of welds at vibration sites. Low-temperature brittle fracture (below -20℃) is characterized by a flat fracture without plastic deformation.
Q2: How to prevent corrosion failure of Q235 steel pipe?
During the design stage, select the anti-corrosion grade according to ISO12944 (such as C4 environment requires ≥240μm coating). Avoid direct contact with copper and stainless steel during installation to cause galvanic corrosion. During maintenance, check the coating damage every six months (scratches> 5mm need to be repaired). Cathodic protection is implemented for buried pipes (potential -0.85~-1.1V). When the medium temperature is greater than 60℃, consider upgrading the material (such as Q355 weathering steel).
Q3: How to analyze cracking of Q235 steel pipe welds?
First, conduct a macroscopic inspection (crack direction, oxidation color) to determine whether it is a welding defect (such as lack of fusion) or service damage. Metallographic analysis can distinguish between hot cracks (along the grain) and cold cracks (through the grain). Scanning electron microscope (SEM) observes the fracture morphology, and hydrogen-induced cracks can be seen as "chicken claws". Chemical analysis is performed to determine whether the weld composition matches the parent material (such as Mn/S ratio ≥30). Finally, check whether the structural stress exceeds the limit (assisted by finite element analysis).
Q4: How to evaluate the residual strength of corroded pipelines?
Calculate the maximum allowable corrosion length according to the ASME B31G formula (L=1.12B√Dt, B is the correction factor). Isolated pits with a depth greater than 80% of the wall thickness need to be replaced immediately. RSTRENG software is used to evaluate the residual strength of large-area corrosion. The grid density of ultrasonic thickness measurement is at least 50mm×50mm. Safety factor should be considered during the assessment (generally 1.5~2.0).
Q5: What are the regular inspection methods for Q235 steel pipes?
Daily inspections include visual inspection (rust, deformation) and hammer listening (layering). Annual comprehensive inspections include ultrasonic thickness measurement (accuracy ±0.1mm) and magnetic particle inspection (surface cracks). Buried pipes are tested for corrosion protection every 3 years (DCVG/CIPS). High-risk areas are screened quickly using guided wave detection (GWDT). Data should be entered into the management system, and the next cycle inspection plan should be formulated in accordance with API 570.








