1. How does two-phase flow affect tube reliability?
Differing vapor/liquid velocities cause flow instability. Water hammer risks during flow regime transitions. Departure from nucleate boiling (DNB) must be avoided. Flow-accelerated corrosion is more severe. Requires careful circulation system design.
2. What is the critical velocity to prevent particulate settling?
Typically 1-3 m/s depending on particle size/density. Below 1 m/s, sedimentation becomes significant. Excessive velocity (>4 m/s) causes erosion damage. Design balances between fouling prevention and erosion control. Computational modeling helps optimize for specific conditions.
3. How do tube inserts affect flow characteristics?
Turbulence promoters enhance heat transfer by 15-30%. Twisted tape inserts improve flow distribution. May increase pressure drop by 20-50%. Must consider erosion potential at high velocities. Often used selectively in problem areas.
4. What causes flow maldistribution in tube bundles?
Uneven header design creates preferential flow paths. Partial blockages from debris or deposits. Density differences in two-phase systems. Improper tube length tolerances. Corrected through proper manifold design and flow restrictors.
5. How does tube surface roughness impact performance?
Increases heat transfer coefficient by promoting turbulence. Raises pressure drop and pumping costs. Accelerates deposit accumulation in some cases. Affects erosion-corrosion rates. Optimal finish depends on service conditions.








