Jun 20, 2025 Leave a message

Basic characteristics and classification of thick-walled steel pipes


Q1: What is the definition and typical wall thickness range of thick-walled steel pipes?
Thick-walled steel pipes usually refer to steel pipes with a wall thickness to outer diameter ratio (t/D) ≥ 0.05, and their absolute wall thickness is generally greater than 20mm. According to industry practice, wall thicknesses of 20-40mm are called conventional thick-walled pipes, 40-75mm are ultra-thick-walled pipes, and 75mm and above are extra-thick-walled pipes. Different standards have slightly different definitions of thick walls. For example, ASME B36.10 classifies SCH80 and above wall thickness series as thick-walled pipes. This type of steel pipe is mainly subjected to high pressure, high load or strong corrosive environment, and is commonly found in petrochemical, electric power and heavy machinery and other fields.

Q2: What are the main material types of thick-walled steel pipes?
The material selection of thick-walled steel pipes depends on the application scenario: carbon steels such as 20#, 45#, Q345B, etc. are used for general pressure-bearing structures; alloy steels such as 15CrMo and 12Cr1MoV are suitable for high-temperature and high-pressure equipment; stainless steels such as 304 and 316L are used in corrosive environments; low-temperature steels such as 09MnNiDR are used for LNG storage and transportation. Special uses also include wear-resistant steel NM360 and hydrogen-resistant steel SA387 Gr11. Material selection needs to comprehensively consider indicators such as strength, toughness, weldability and corrosion resistance, and performance is usually improved by adding alloy elements such as Cr, Mo, and Ni.

Q3: What are the performance differences between thick-walled seamless pipes and thick-walled welded pipes?
Thick-walled seamless pipes are produced by perforation rolling, and have the characteristics of dense organization and high pressure bearing. The bursting pressure is usually 15-20% higher than that of welded pipes of the same specification. Welded pipes (such as SAWL or ERW) need to be heat treated to improve the uniformity of the organization due to the presence of welds, but the production cost is 30-40% lower. Seamless pipes are more suitable for ultra-high pressure (>50MPa) and alternating loads, while welded pipes are more economical in large diameter (>Φ500mm) applications. There are also significant differences between the two in terms of low temperature toughness and fatigue life, and they need to be selected according to the working conditions.

Q4: What does the manufacturing standard system of thick-walled steel pipes include?
International mainstream standards include: ASME SA106 (carbon steel pipes for high temperature), ASME SA335 (alloy steel pipes), API 5L (line pipes), ASTM A312 (stainless steel pipes), etc. Chinese standards such as GB/T 8163 (fluid pipes), GB 6479 (fertilizer equipment pipes), and GB 5310 (boiler pipes) also have detailed regulations. These standards have special requirements for the chemical composition, mechanical properties, and test items of thick-walled pipes. For example, thick-walled pipes need to add Z-direction performance tests to prevent laminar tearing.

Q5: What are the main failure modes and preventive measures for thick-walled steel pipes?
Common failures include: inner wall corrosion thinning (annual corrosion rate>0.5mm requires early warning), stress corrosion cracking (control hardness HB≤225), fatigue fracture (optimize structure to avoid stress concentration) and high temperature creep (limit use temperature). Preventive measures include: selection of corrosion-resistant materials, PWHT to eliminate residual stress, regular ultrasonic thickness measurement, setting corrosion allowance (usually 3-6mm) and implementing integrity management (RBI). For extreme environments, composite pipes or cladding anti-corrosion layers can be used.

info-284-177info-259-194info-225-225

Send Inquiry