- There are two main types of corrosion in pipelines:
1. Electrochemical corrosion: Since oil and gas wells contain corrosive gases such as CO2 and H2S, electrochemical corrosion is prone to occur in underground oil and gas pipelines. Therefore, electrochemical corrosion is relatively common in pipelines.
2. Local corrosion: Local corrosion is a type of corrosion that is particularly serious for pipelines. Common types of local corrosion in pipelines include: stress corrosion cracking, crevice corrosion, galvanic corrosion, hydrogen corrosion, corrosion fatigue, etc.
Regarding the corrosion problem of oil pipelines, since the main corrosion principles are electrochemical corrosion and local corrosion, the anti-corrosion effect of general coatings is certainly not optimistic. The working environment and working nature of petroleum determine the difficulty of coating. , high cost and inconvenient operation. If you want to extend the service life of your pipelines, you need to maintain them regularly.

- So how to prevent oil pipeline corrosion?
1. The inner wall is coated with anti-corrosion layer. Commonly used coatings include amine-cured epoxy resin and polyamide epoxy resin, with coating thicknesses of 0.038 to 0.2 mm. In order to ensure that the coating is firmly bonded to the pipe wall, the inner wall of the pipe must be surface treated.
2. Anti-corrosion coating on the outer wall. Applying paint evenly to the surface of the rust-removed metal pipeline to isolate it from various corrosive media is one of the basic methods of pipeline anti-corrosion. In modern times, pipeline anti-corrosion coatings increasingly use composite materials or composite structures. These materials and structures must have good electrolytic performance, physical properties, stable chemical properties and a wide temperature adaptation range.
3. Plating and coating. The coating of steel is formed by plating a layer of metal on the surface of steel using techniques such as electroplating, spraying, and heat. The coating is divided into two types: anode coating and cathode coating. The potential of the coating is more negative than the potential of the base metal. It is an anode coating. The main principle is the cathodic protection method of sacrificial anode. This method is especially suitable for metals with rough metal surfaces. Another type of plating with a higher potential than the plated layer is a negative plating. This kind of coating has higher requirements on the metal to be plated and needs to be complete, otherwise it will easily accelerate the corrosion of the metal.
4. Corrosion inhibitor. Adding a small amount of substances to corrosive media can reduce or even inhibit the corrosion rate. The corrosive agent is easy to apply, has quick effect and has good economic effect.






