Jul 15, 2025 Leave a message

Anti-corrosion and maintenance of Q215 steel pipe

What are the anti-corrosion strategies for Q215 steel pipe in different environments?
In ordinary atmospheric environment, hot-dip galvanizing can provide more than 10 years of protection. In industrial pollution areas or coastal areas, it is recommended to use epoxy resin coating + galvanizing composite protection. When buried underground, enhanced anti-corrosion (such as 3PE anti-corrosion) is required. In high temperature environment, high temperature resistant anti-corrosion coating (such as silicone coating) should be selected. In special chemical corrosion environment, special protection such as lining plastic or fiberglass coating should be considered.
How to evaluate the service life of Q215 steel pipe galvanized layer?
According to the thickness of the galvanized layer, each micron of zinc layer can be protected for 1-2 years in a general atmospheric environment. The salt spray test can accelerate the evaluation of the corrosion resistance of the galvanized layer. Regularly check the surface state of the zinc layer, and the appearance of white rust is a signal for the start of protection. The environmental corrosion grade (ISO 9223 standard) is an important reference for evaluating the service life. The actual service life also needs to consider factors such as ambient temperature, humidity, and pollutant concentration.
What are the common methods for corrosion detection of Q215 steel pipes?
Visual inspection is the most basic method, focusing on corrosion-prone areas such as welds and joints. Ultrasonic thickness gauges can quantitatively measure the remaining thickness of the pipe wall. Electrochemical detection methods (such as polarization resistance method) can evaluate the corrosion rate. Infrared thermal imagers can detect corrosion problems in hidden areas. For important pipelines, intelligent detectors (PIG) can be used for internal inspection.
What are the repair technologies for local corrosion of Q215 steel pipes?
Small area corrosion can be repaired by mechanical grinding and then welding. For pitting pits, they can be cleaned and filled with metal repair agents. Large area corrosion can be strengthened by patching steel plates. Polymer repair materials (such as fiberglass composite materials) are suitable for rapid on-site repair. After repair, anti-corrosion treatment must be carried out again to ensure the continuity of protection.
What are the anti-rust measures for Q215 steel pipes during storage?
Indoor storage should keep the environment dry and the relative humidity below 60%. When stored in the open air, it should be raised and covered to prevent water corrosion. Protective caps should be installed on the pipe ends to prevent rust at the cuts. Regularly check the surface condition of the stored steel pipes to detect rust in time. It is recommended to spray anti-rust oil or vapor phase rust inhibitor on steel pipes stored for a long time.

info-275-183info-270-187info-225-225

Send Inquiry