1. What is A671 CH115 Class 10 Steel Pipe?
Answer:
A671 CH115 Class 10 is a carbon steel electric-fusion-welded (EFW) pipe conforming to ASTM A671 standards, where:
"CH115" indicates a high-strength carbon steel grade with enhanced alloying elements (e.g., Mn, Si).
"Class 10" specifies a lower pressure rating compared to higher classes (e.g., Class 22/70), typically used for moderate-pressure applications.
Key Features:
Pressure Rating: Suitable for systems with ≤10 MPa design pressure.
Temperature Range: Standard service from -20°C to 150°C (-4°F to 302°F).
Construction: Longitudinal seams welded via submerged arc welding (SAW).
2. Typical Applications of Class 10 Pipes
Answer:
Commonly used in:
Industrial Plumbing: Low-pressure water/gas distribution.
HVAC Systems: Ductwork and coolant lines.
General Fabrication: Structural supports, non-critical process piping.
Note: Not recommended for cryogenic or high-stress environments due to limited impact toughness.
3. How Does Class 10 Differ from Higher Classes (e.g., Class 22)?
Answer:
| Parameter | Class 10 | Class 22 |
|---|---|---|
| Pressure Rating | ≤10 MPa | Higher (e.g., ≥22 MPa) |
| Testing | Spot radiography (RT) | 100% RT |
| Material Toughness | Standard Charpy tests (if any) | Mandatory low-temperature testing |
Key Difference: Class 10 has lighter testing requirements and lower material costs.
4. Material and Mechanical Specifications
Answer:
Chemical Composition:
Carbon: ≤0.25%, Manganese: ≤1.00%, Silicon: 0.10–0.35%.
Mechanical Properties:
Tensile Strength: ≥380 MPa
Yield Strength: ≥205 MPa
Charpy V-notch: Optional (not required for Class 10).
Dimensions: Sizes range from 1/2" to 24" OD, wall thickness per ASME B36.10.
5. Fabrication and Quality Control
Answer:
Welding: SAW with visual inspection and spot RT (per customer request).
Testing:
Hydrostatic test at 1.5x design pressure.
No mandatory impact testing unless specified.
Certification: Basic Mill Test Reports (MTRs) with chemical/mechanical data.
Standards Compliance: ASTM A671 (base standard), ASME B31.1/B31.3 for installation.






